ES47 Surgical Scrub Sink
The Dual Bay ES47 Surgical Scrub Sink was developed to be the answer to space and economical constraints where needed. Compared to the SS-Series, these scrub sinks have smaller outside dimensions but still maintain a deep basin to allow for proper scrubbing. The operation is the same as the SS-Series, however, some of the features vary.
Description
ES47 Surgical Scrub Sink Features
The Dual Bay ES47 Surgical Scrub Sink was developed to be the answer to space and economical constraints where needed.
- Deep sloping basin
- Adjustable thermostatic controlled pressure regulating mixing valve (one per station, mounted under the sink)
- Knee operated water (optional with IR sinks)
- High mount swivel gooseneck spout with adjustable swivel spray aerator
- Flow control valve
- Backflow preventers
- Infrared sinks are equipped with a 24-volt plug-in transformer
- Z-brackets (See specifications on the rear panel for wall support)
- 304 stainless steel polished and ground to a #4 finish
Optional Features
- Infrared operation
- Manual bypass to add knee operated water with IR operation
- Knee operated water with IR water operation
- Knee operated soap with IR water operation
- Foot-operated water
- Foot-operated soap
- Digital scrub timer
- Eyewash
- Thermostatic mixing valve (add on to eyewash option)
- Laminar flow
- 220/240V power supply
- Pedestal base
ES47 Surgical Scrub Sink Specifications
- MATERIAL:
- Sink Basin and Sink Top: 14 gauge, 300 series stainless steel
- Sink Skirt: 18 gauge, 300 series stainless steel
- ALL PLUMBING 1/2 COPPER OR BRASS PIPE
- UTILITY REQUIREMENT
- COLDWATER 20 TO 50 PSIG 70 DEG F MAX
- HOT WATER 20 TO 50 PSIG 120 DEG F TO 140 DEG F
- The Customers Responsibility:
- To ensure by use of pressure regulators or other means, that maximum specified pressures are not exceeded.
- To ensure that water supplies are properly protected for internal cross-connection control in accordance with local building and plumbing requirements.
- To eliminate water hammer conditions should they occur in the service piping.
- POWER REQUIREMENTS (FOR SENSOR OPERATIONS)
- 120 VAC, 60 Hz, SINGLE PHASE, 3.0 AMP OR 220 VAC, 60 Hz, SINGLE PHASE, 1.5 AMP
- INSTALLED PER LOCAL BUILDING CODES
- NET WEIGHT OF SINK 230 LBS
Wall Mounting Brackets (Included)
